Katool KT-4H850 8,500 lb Heavy-Duty 4-Post Car Lift with Caster Kit
KATOOL Four-Post Vehicle Lifts
Vehicle storage and service with included caster kit, drip trays, and jack tray.
The KATOOL KT-4H850 is an 8,500 lb capacity four-post lift for vehicle storage and shop service. Drive-on runways support compatible cars, SUVs, and light-duty trucks without requiring arm positioning at individual lifting points. Its included caster kit allows the unloaded lift to be repositioned according to the manufacturer's instructions.
For service work, the open space between the runways provides access to the underside of the vehicle. The supplier lists a single-point manual lock release, four mechanical locks, a secondary slack-cable safety system, adjustable lock ladders, and a hydraulic power system. Three drip trays and one jack tray are listed as included.
Wheel-free brake and suspension service requires a separately compatible rolling bridge jack or other approved lifting method; the included jack tray is not itself a lifting jack.
| Model | KT-4H850 |
|---|---|
| Lift type | Drive-on four-post vehicle lift |
| Rated lifting capacity | 8,500 lb (approximately 3,850 kg) |
| Maximum lifting height | 70.87 in (1,800 mm) |
| Minimum runway height | 4.76 in (121 mm) |
| Post height | 83.66 in (2,125 mm) |
| Overall width | 107.95 in (2,742 mm) |
| Overall length with ramps | 198.43 in (5,040 mm) |
| Width inside columns | 94.72 in (2,406 mm) |
| Approximate lift/lower time | 75 seconds up / 40 seconds down |
| Standard motor supply | 110 V AC / 60 Hz / single phase |
| Optional power configuration | 220 V / 60 Hz / single phase; confirm availability before ordering |
| Net weight | Approximately 1,820 lb (826 kg) |
| Listed accessories | Caster kit, three drip trays, and one jack tray |
Check the full lift length with ramps, overall width, vehicle dimensions, and ceiling height for both the raised vehicle and any vehicle stored beneath it. Confirm the selected vehicle fits the runways, weight rating, and clearances in the current manufacturer documentation. The caster kit is intended for repositioning as directed by the manufacturer; do not move the lift with a vehicle raised on it.
The supplier states that concrete must be at least 3.93 inches (100 mm) thick and rated 3,000 psi. A qualified installer should verify the actual slab, any anchoring requirements, the lift's current installation instructions, and applicable local requirements before installation. Confirm electrical service and the supplied motor voltage as well.
Specifications and included components are based on the supplier's KT-4H850 listing. Verify the current configuration, accessories, and installation manual before ordering.